One of the really great features of this saw also creates a problem for extending the table. I always feel safer with the wood base between my hand and the saw blade.Ī small saw is practical for a small shop but I found that the table was a little too short, so I decided to extend the back. Also for smaller pieces of material I find that the design of the handle allows me to easily apply pressure both down and towards the fence. ![]() I find it very handy when I am cutting a long board, that once I get near the end, to just grab the handle and finish the cut using the push handle to push past the blade. I just drilled and taped the fence for the bolts to hold it on. To make it always readily available, I mounted a strip of plastic on the back of my fence using standoffs to create a slot for the handle to drop into. If you make it too deep it will catch on the table if you are cutting thin material. The hook I cut at the back edge only needs to be big enough to bite into the back of the material. I made the actual pushing piece from Plexiglas to allow me to better see what was going on. And I also wanted my hand to be protected, so I built a wide base with a handle to allow me to apply pressure to hold the material safely. In designing my push handle I wanted it to be able to hold the material down and against the fence. I wanted a push handle that would always be handy whenever I needed it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |